Auto Stringer (Small Cut Cell) ULC-3000A
Name:
Auto Stringer (Small Cut Cell) ULC-3000A
Introduction:
The product is suitable for PV module assembly line. Use to soldering the solar cells with ribbon strips to string.Mainly used in small module, From 1-75W.
Advantage:
It is highly compatible with 39 / 52 / 62.5/78/104/125/156 wide cell size 1,2,3,4,5,6BB cells.
High degree of automation, safe, reliable and simple operation, stable operation and low noise.
The system can automatically adjust the soldering action according to the set number of series connected pieces to make the output cell string reach the required number.
Short soldering time, fast energy saving and high fusion strength.
Configure:
- Cycle Time: 4.5Sec/Cycle
- Breakage Rate: ≤3-5‰
- Ribbon Mis-alignment: ≤0.3mm
- Load transfer system: AC servo motor drives the load transfer suction device at high speed
- Heating mode: whole section heating, PID control electric heater heating, temperature adjustable
- Cell spacing: 0.2 ~ 10.0mm ± 0.5mm (adjustable)
- Maximum string length: ≤ 580mm / String
- Number of BB lines: 1-6BB
